Fault Table - Gaggenau DF480 Notice D'utilisation

en-us
Troubleshooting

Fault table

Fault
Error code ":‚‰ is lit.
Error code ":‹ˆ is lit.
Error code ":‚ƒ is lit.
Error code ":ƒƒ is lit.
Error code ":ƒ... is lit.
Error code ":Ġ is lit.
Error code ":ƒˆ is lit.
A different error code is
indicated on the digital display.
(":‹‚ to ":„‹)
Refill indicator for salt P and/
or rinse-aid H is lit.
Refill indicator for salt P and/
or rinse-aid H is not lit.
42
Cause
Supply hose kinked.
Tap turned off.
Tap jammed or calcified.
Filter in the water supply blocked.
Intake opening (on right inside of
appliance) covered by dishes.
Heating element calcified or soiled.
Filters 1Z are soiled or blocked.
Waste-water hose kinked or blocked. Install hose without kinks, remove any
Siphon connection still sealed.
Cover on the drain pump loose.
Drain pump blocked or cover on the
drain pump is not locked in position.
Mains voltage too low.
A technical fault has probably
occurred.
No rinse aid.
No salt.
Sensor does not detect salt tablets.
Refill indicator switched off.
There is still enough special salt/
rinse aid available.
Remedial action
Install supply hose without kinks.
Turn on the tap.
Turn on the tap.
Flow rate must be min. 10 l/min. when water
supply is open.
Switch off the appliance and pull out the
mains plug. Turn off the tap. Unscrew water
connection.
Clean filter in the supply hose. Screw water
connection on again. Check for leaks.
Reconnect power supply. Switch on the
appliance.
Arrange dishes so that the intake opening is
not obstructed.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the
setting.
Clean filters.
residue.
Check connection to siphon and open if
required.
Lock cover correctly.
Clean pump and lock cover correctly.
Not an appliance fault, have the mains
voltage and electrical installation checked.
Switch off appliances with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the error
code.
Refill rinse aid.
Refill with special salt.
Use different special salt.
Activation/deactivation ~ ", Rinse Aid", ~ "+
Water softening system / special salt"
Check refill indicator, levels.