Setting The Amount Of Rinse Aid Used; Switching Off Rinse Aid Refill Indicator - Gaggenau DF480 Notice D'utilisation

Masquer les pouces Voir aussi pour DF480:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.
Close the lid. Lid must be fully closed until it clicks in
order to seal.
4.
Wipe up any excess rinse aid that may have puddled
when the dispenser reservoir is full.
This prevents excessive frothing during the next wash
cycle. The indicator light will go out a few moments
after the dishwasher door is shut.
Tip: For easier pouring, remove lid from the rinse aid
bottle.
NOTICE: Do not fill the rinse aid dispenser 9" with
detergent. Doing so will damage the dishwasher.

Setting the amount of rinse aid used

The amount of rinse aid to be dispensed can be set from
0 to 6. Set the amount of rinse aid to be dispensed to 5
to obtain a very good drying result. Do not change the
amount of rinse aid unless there are streaks or water
stains on the utensils. Set a lower level to avoid streaks.
Set a higher level to avoid water stains.
Set the amount of rinse aid as follows:
1.
Open the door.
Press on ON/OFF button (.
2.
Press Info button ( 8 for 3 seconds until the
3.
following text is indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with t 3 sec.
Keep pressing button > )* until the rinse aid
4.
dispenser is indicated on the display window at the
top @.
5.
Make the selection with setting buttons + - X.
6.
Press and hold the Info button (8 for 3 seconds.
The chosen setting has now been stored.
Note: Do not change the amount of rinse aid unless
there are streaks (select lower setting) or water stains
(select higher setting) visible on the utensils.
Switching off rinse aid refill
indicator
If the use of combined detergents with a rinse aid
component impairs the low rinse aid indicator H on
the control panel (enough rinse aid for x rinse cycles),
the displays can be switched off.
Proceed as described under "Setting amount of rinse
aid" and select setting 0.
NOTICE: Using no rinse aid or setting the dispenser
to 0 may result in longer cycle times consuming more
energy and water. The higher temperatures can damage
fine china or glassware.
en-us
Rinse Aid
17

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Df481

Table des Matières