Switching Off The Appliance; Interrupting The Wash Cycle; Terminating The Wash Cycle; Changing The Wash Cycle - Gaggenau DF480 Notice D'utilisation

Switching off the appliance

Short time after the end of the wash cycle:
Press On/Off button (.
1.
2.
Remove the dishes when they have cooled down.
9
WARNING
Risk of injury!
To avoid risk of injury, always use caution when
opening the door during or following a wash cycle
as hot water or steam may escape. Do not fully
open the door until water noises have stopped
and steam has subsided.
To reduce risk of injury, do not allow children to
play in or on the dishwasher.
When children become old enough to operate the
appliance, it is the responsibility of the parents/
legal guardians to ensure the children are
instructed in safe practices by qualified persons.
Operating the Dishwasher

Interrupting the wash cycle

9
CAUTION!
Expansion (overpressure) may cause the
appliance door to open and/or water to escape! If
the door was opened on an appliance which has a
hot water connection or is heated, always leave
the door ajar for several minutes and then close.
1.
Open the door.
2. Switch off On/Off switch (.
The LED's go out. The wash cycle is saved.
3.
To continue the wash cycle, switch on the On/Off
switch ( again.
4.
Close the door.
Note: Your dishwasher is protected against
unintentional operation. If the appliance door remains
open for more than 4 seconds after pressing the Start
button, the operation will be paused. Press the Start
button again and close the appliance door.
Terminating the wash cycle (Reset)
1 .
Open the door.
T e r m i n a t i n g t h e w a s h c y c l e
Press the Start button )" and hold for 3 seconds
2.
The digital display @ shows: "Program was
terminated".
3.
Close the door.
The wash cycle sequence lasts approx. 1 min. The
digital display @ shows: "Finished".
4.
Open the door.
Switch off On/Off switch (.
5.
6.
Close the door.

Changing the wash cycle

When the Start button ( has been pressed, the wash
cycle cannot be changed. The only way a wash cycle can
be changed is by terminating the wash cycle (Reset).
en-us
37