Gaggenau DF480 Notice D'utilisation page 43

Fault
Water is left in the appliance at
the end of the wash cycle.
Dishes not dry.
Plastic dishes not dry.
Silverware not dry.
Appliance interior wet after rinse
cycle.
Cause
Filter system or area under the filters
1Z is blocked.
Wash cycle has not ended yet.
No or too little rinse aid in the
dispenser.
Wash cycle selected without drying.
Water collecting in depressions on
the dishes and silverware.
The combined detergent used has a
poor drying performance
extraDry to increase drying not
activated.
Dishes were removed too early or
drying process had not ended yet.
The eco rinse aid used has a limited
drying performance.
Special properties of plastic.
Silverware not arranged properly in
the silverware basket.
Silverware not arranged properly in
the third rack.
No appliance fault.
Troubleshooting
Remedial action
Clean filters and area underneath.
Wait until wash cycle ends or reset.
Refill rinse aid.
Select wash cycle with drying.
Arrange dishes in a sloping position,
arrange affected dishes as sloping as
possible.
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Activate extraDry.
Wait until wash cycle ends or wait until 30
min after wash cycle ends before removing
dishes.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic has a lower heat storage capacity
and therefore dries less well.
Separate silverware if possible, prevent
contact points.
Arrange silverware properly and separate if
possible.
On account of the "Condensation drying"
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
en-us
43