Bosch Drive Unit Cruise Notice Originale page 26

OBJ_BUCH-1407-005.book Page 5 Tuesday, October 8, 2013 9:41 AM
English–5
The following basic settings are available:
– "unit km/mi": The speed and distance can be displayed
either in kilometres or miles.
– "time format": The time can be displayed either in the
12 hour or 24 hour format.
– "clock": The current time can be set here. Pressing and
holding the setting buttons fast-forwards the setting
speed.
– "English": The language for text indication can be
changed. The available languages are German, English,
French, Spanish, Italian and Dutch.
– "power-on hours": Indicates the total travel duration with
the eBike (not changeable).
Code Cause
Internal error of the drive unit
100
Connection problem of the drive unit
101
Error of the speed sensor
102
Connection problem of the lighting system Have connections and contacts checked
103*
Connection problem of the HMI
104
Temperature of the drive unit too high
105
(above 40 °C)
200
Internal electronic error of battery pack
201 Temperature of the battery pack too high
(above 40 °C)
202
Temperature of the battery pack too low
(below –10 °C)
203 Connection problem of battery pack
204
Incorrect polarity of battery pack
One or more buttons of the HMI are
410
blocked.
Connection problem of the operating unit
414
One or more buttons of the operating unit
418
are blocked.
Connection problem of the drive unit
422
Connection problem of battery pack
423
Communication error among the
424
components
430 Internal battery pack of HMI empty
490 Internal error of the HMI
No display
Internal error of the HMI
* only for eBike lighting via battery pack (country-specific)
0 276 001 YYY | (8.10.13)
Error Code Indication
The components of the eBike system are continuously and au-
tomatically monitored. When an error is detected, the respec-
tive error code is indicated in text indication d.
To return to the standard indication, press any button on the
HMI 3 or on the operating unit 10.
Depending on the type of error, the drive is automatically shut
off if required. Continued travel without assistance from the
drive is possible at any time. However, have the eBike
checked before attempting new trips.
 Have all checks and repairs performed only by an
authorised bike dealer.
Corrective Measure
Have the drive unit checked
Have connections and contacts checked
Have the speed sensor checked
Have connections and contacts checked
Allow the drive unit to cool down. Continued travel without
assistance from the eBike drive is possible and speeds up the cooling
of the drive unit.
Have battery pack checked
Allow the battery pack to cool down. Continued travel without eBike
drive is possible and speeds up the cooling of the battery pack.
Allow the battery pack to warm up slowly in a warm location.
Have connections and contacts checked
Charge the battery pack with the original Bosch charger as described
in the operating instructions.
Check if any buttons are blocked, e.g. from dirt or debris. Clean the
buttons, if required.
Have connections and contacts checked
Check if any buttons are blocked, e.g. from dirt or debris. Clean the
buttons, if required.
Have connections and contacts checked
Have connections and contacts checked
Have connections and contacts checked
Charge HMI (in holder or via USB port)
Have the HMI checked
Restart your eBike system by switching it off and back on.
Bosch eBike Systems