Machine Function Messages - Victoria Arduino VA 358 WHITE EAGLE Manuel D'instructions

8.

MACHINE FUNCTION MESSAGES

DISPLAY AND KEY
INDICATIONS
At the time of the diagno-
sis the system presents
DIAGNOSIS OF ERROR
faults within the control unit
On reaching delivery time
DELIVERY ERROR
er doesn't send out its set
If the doser doesn't send
out its set commands within
DOSER ERROR
LEVEL ERROR functioning the water level
When the machine's tem-
PRESSURE ERROR perature is higher than
Incorrect electrical input
OVERCURRENT ERR. caused by a malfunction in
one of the machine charges.
The machine registers val-
FINE GRINDING ues different from the set
The machine registers val-
COARSE GRINDING ues different from the set
66
CAUSE
functioning the water level
is not re-established.
The display indicator and
- the 'continuous' key belong-
ing to the relative unit will
commands.
If the delivery isn't manu-
ally halted, the maximum
delivery onset.
on and off. The pump is de-
activated. The resistor and all
is not re-established.
the functions are halted.
The display indicator will
130°C. sistor is de-activated.
The display reading will
off. The heating element
and all other functions will
A much longer delivery time.
values.
A much shorter delivery
values.
EFFECT SOLUTION
blocked.
Turn the machine off and
then turn it on again. All its
functions will be re-activated.
The system will be re-estab-
- lished as soon as the tem-
perature goes below 130°C.
Switch off the machine and
send for a specialist techni-
cal engineer.
be disabled.
Modify grinding degree and
press the key RESET or
time.
NOTE
.
.
The boiler is provided with
thermostat; if the resistor
is not re-established, call a
the programming state, with-
in 10 minutes from the last
selection, the system will re-
.
ration and the display will in-
dicate its reestablishment of
normal functioning.
.
-