Programming; Key; Visualization (User Mode) - Victoria Arduino VA 358 WHITE EAGLE Manuel D'instructions

5.

PROGRAMMING

5.1

KEY

3
2
1
5
4
LCD Display.
①
RESET key: to confirm and return
②
to the previous step.
CURSORS key: to scroll the menu and
③
to increase and
④
decrease values.
ENTER key: to access the menu.
⑤
ACCESS TO MENÙ:
button and confirm with the
Menu
ENTER key.
The display of the menu can be set to two
modes:
USER (password enabled);
TECHNICIAN (password disabled).
The machine has the password off by default,
with the ability to access the full menu.
If a password was set, accessing the menu you
will be asked to enter a password:
INSERT PASSWORD
- -
1.21 bar
To enter USER mode, press ENTER without
changing any value.
Fig. 21
To enter TECHNICIAN Mode, enter the pass-
ENTER.
5.2 VISUALIZATION
(USER Mode)
LIST OF DISPLAY FUNCTIONS (USER Mode)
AUTO. CLEAN. CYCLE
DOSES
DELIVERY COUNT
TOTAL
MACHINE TOTAL
CLEANING COUNTER
The machine will read:
AUTO.CLEAN.CYCLE
DOSES
DELIVERY COUNT
TOTAL
MACHINE TOTAL
CLEANING COUNTER
1.21 bar
AUTOMATIC CLEANING CYCLE:
Sunday 21 March 14:45
- -
Sunday 21 March 14:45
Sunday 21 March
AUTO.CLEAN.CYCLE
DOSES
DELIVERY COUNT
TOTAL
MACHINE TOTAL
CLEANING COUNTER
1.21 bar
ENTER and the display will read:
Sunday 21 March
AUTO.CLEAN.CYCLE
SELECT
1.21 bar
The key in each unit will begin to flash
on and off. Insert the blind filter into the filter-
holder, add half a dose of detergent and
attach the filter-holder into the unit where
you intend to carry out the automatic clean-
ing cycle. Carrying out a cleaning cycle in
more than one unit at a time is possible.
key to start the unit automatic
cleaning cycle. The display will read:
14:45
14:45
53