Energy Saving - Victoria Arduino VA 358 WHITE EAGLE Manuel D'instructions

The display will read:
Sunday
DAY OFF
1.21 bar
(to reinstate, press RESET)
a beep will signal that you have come to the
following page.

ENERGY SAVING:

Sunday
PROGRAM DOSES
AUTO.CLEAN.CYCLE
DELIVERY COUNT
ON-OFF PROGRAM
ENERGY SAVING
CUP-WARMER PROG.
1.21 bar
This function allows the machine to enter standby
mode or not, which makes it possible to choose
whether or not to switch off the machine com-
pletely or to keep it at a set pressure (less than
working levels).
21 March 14:45
STANDBY
1.21 bar
0.10 bar: during the OFF state, the machine
maintains a pressure of 0.10 bar.
0.50 bar: during the OFF state, the machine
maintains a pressure of 0.50 bar.
0.80 bar: during the OFF state, the machine
maintains a pressure of 0.80 bar.
ENTER to confirm the required option.
This operation is used with both manual switching
on/off using the button ON /OFF, and automatic
21 March 14:45
switching on/off by programming the machine.
If the on/off button is pressed during one of the
three active standby states (0.10 bar, 0.50 bar,
0.80 bar), the machine will switch off completely.
If the button is pressed again, this will switch on
the machine.
CUP-WARMER PROGRAMMING:
PROGRAM DOSES
AUTO.CLEAN.CYCLE
DELIVERY COUNT
ON-OFF PROGRAM
ENERGY SAVING
CUP-WARMER PROG.
1.21 bar
Sunday 21 March 14:45
ENERGY SAVING
XXX bar
keys
to select the following options.
Sunday 21 March 14:45
to select with the
cup warmer programming mode:
ENTER to confirm.
Programming timed:
ENTER will cause the display to
read, for example:
Sunday
CUP-WARMER PROG.
ON XX OFF xx
1.21 bar
The message ON XX will begin to flash; use
open time.
ENTER to confirm and pass to the cup
warmer OFF time.
NOTE: Setting one of the two ON/OFF values
to 0 will automatically bypass the func-
tion (example of reference times ON: 5
RESET to pass to the next page.
Programming adjusted:
to vary the cup warmer
temperature set-point.
ENTER to confirm and pass to the
next page.
21 March 14:45
59