DeWalt DWE402 Guide D'utilisation page 13

See the Accessories Chart for information on choosing the correct
accessories.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other accessories
running over their rated accessory speed may fly apart and cause
injury. Threaded accessories must have a 5/8"-11 hub. Every
unthreaded accessory must have a 7/8" (22.2 mm) arbor hole. If it
does not, it may have been designed for a circular saw. Use only the
accessories shown in the Accessories Chart of this manual.
Accessory ratings must always be above tool speed as shown on tool
nameplate.
WARNING: Handle and store all abrasive wheels carefully to
prevent damage from thermal shock, heat, mechanical damage, etc.
Store in a dry protected area free from high humidity, freezing
temperatures or extreme temperature changes.
Mounting Guard
CAUTION: Guards must be used with all grinding wheels,
cutting wheels, sanding flap discs, wire brushes, and wire
wheels. The tool may be used without a guard only when sanding with
conventional sanding discs. A Type 1 guard (intended for use with
Type 1 cutting wheels and Type 27 wheels marked for cutting only) is
available at extra cost from your local dealer or authorized service
center. Grinding with wheels other than Type 27 and Type 29 require
different accessory guards not included with the tool. A type 27 guard
is provided for use with a 1/4" (6.35 mm) thick Type 27 wheel.
NOTE: Edge grinding and cutting can be performed with Type 27
wheels designed and specified for this purpose; 1/4" (6.35 mm)
thick wheels are designed for surface grinding while thinner Type 27
wheels need to be examined for the manufacturer's label to see if
they can be used for surface grinding or only edge grinding/cutting.
A Type 1 guard must be used for any wheel where surface grinding
is forbidden. Cutting can also be performed by using a Type 1 wheel
and a Type 1 guard.
NOTE: See the Accessories Chart to select the proper guard /
accessory combination.
MOUNTING, ADJUSTING AND REMOVING (TYPE 27)
ONE-TOUCH™ GUARD (FIG. 3)
Your grinder is supplied with a keyless ONE TOUCH™ guard.
1. Press the guard release lever (J).
2. While holding the guard release lever open, align the lugs (M) on
the guard with the slots (N) on the gear case.
3. Keeping the guard release lever open, push the guard down until
the guard lugs engage and rotate them in the groove on the gear
case hub. Release the guard release lever.
4. With the spindle facing the operator, rotate the guard clockwise
into the desired working position. The guard body should be
positioned between the spindle and the operator to provide
maximum operator protection.
5. For easy adjustment, the guard can be rotated in the clockwise
direction. The guards design allows the guard to be
rotated and adjusted by turning the guard in a clockwise,
single action motion. The lever does not need to be
depressed to turn the guard. The lever is only used for
removal of the guard. The guard can be repositioned the
opposite direction by depressing the guard release lever.
NOTE: The guard release lever should snap into one of the
alignment holes (O) on the guard collar. This ensures that the
guard is secure.
6. To remove the guard, follow steps 1–3 of these instructions in
reverse.
11