Ryobi CDD-1202 Manuel D'utilisation page 13

GB
F D
CHARGER SAFETY
To reduce risk of injury, charge only nickel-cadmium
■
type rechargeable batteries. Other types of batteries
may burst, causing personal injury and damage.
Do not expose charger to wet or damp conditions.
■
Use of an attachment not recommended or sold by
■
the battery charger manufacturer may result in a risk
of fire, electric shock, or injuries to person.
To reduce risk of damage to charger body and cord,
■
pull by charger plug rather than cord when
disconnecting charger.
Make sure cord is located so that it will not be
■
stepped on, tripped over, or otherwise subjected to
damage and stress.
An extension cord should not be used unless
■
absolutely necessary. Use of improper extension cord
could result in a risk of fire and electric shock. If
extension cord must be used, make sure:
a. That pins on plug of extension cord are the same
number, size and shape as those of plug on charger.
b. That extension cord is properly wired and in good
electrical condition.
Do not operate charger with a damaged cord or plug.
■
If damaged, have it replaced immediately by a
qualified serviceman.
Do not operate charger if it has received a sharp
■
blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman.
Do not disassemble charger; take it to a qualified
■
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire.
To reduce risk of electric shock, unplug the charger
■
from outlet before attempting any maintenance or
cleaning. Turning off controls will not reduce this risk.
Disconnect charger from power supply when not in
■
use.
Risk of electric shock. Do not touch uninsulated
■
portion of output connector or uninsulated battery
terminal.
Save these instructions. Refer to them frequently and
■
use them to instruct others who may use this unit. If
you loan someone this unit, loan them these
instructions also.
E I P NL S DK N FIN
English
DESCRIPTION
See Figure 1-9
1. Keyless chuck
2. Switch trigger
3. Direction of rotation selector (Forward/Reverse)
4. Screwdriver bits
5 . Battery pack
6. Magnetic tray
7. Latches
8. Depress latches to release battery pack
9. Auxilary Handle (For CDI-1442 / 1802)
10. To Tighten
11. To Loosen
12. Drill bit
13. Depth Gauge Rod
14. Drilling Depth
15. To Decrease torque
16. To Increase torque
17. Torque adjusting Ring
18. Drill mode
19. Impact mode (For CDI-1442 / 1802)
20. Reverse
21. Forward
22. Chuck jaws
23. Unlock (release)
24. Lock (tighten)
25. High Speed
26. Low Speed
27. Battery Charger
28. Green Light
29. Red Light
OPERATION
LED FUNCTION OF CHARGER
See Figure 9.
LED WILL BE ON TO INDICATE STATUS OF CHARGER
AND BATTERY PACK:
Red LED on = Fast charging mode.
■
Green LED on = Fully charged battery pack.
■
No LED on = Defective charge or battery pack.
■
CHARGING YOUR BATTERY PACK
The battery pack for your tool has been shipped in a low
charge condition to prevent possible problems.
Therefore, you should charge it prior to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles for them to
fully charge.
9
GR H CZ RUS RO PL