Operating Elements And Connections - Monacor Security TVCCD-462COL Mode D'emploi

Please unfold page 3. Then you can always
see the operating elements and connections
described.
1 Operating Elements and Connec-
tions
(fig. 1 and 2)
1 Lens cover
2 C-mount adapter ring for screwing on a
C-mount lens
3 Threaded ring for screwing on a CS-mount
lens
4 Hexagon socket screws for readjusting the
mechanical focus setting for the lens
5 One DIP switch each for the following func-
tions (see chapter 7.1):
– backlight compensation,
activated ("BLC") or deactivated ("OFF")
– automatic electronic shutter,
activated ("ESC") or deactivated ("OFF")
– automatic white balance
two operating modes available: "AWB" or
"ATW"
6 BNC jack for the video output
7 Power LED
8 Terminals +12 V and GND for connecting the
power supply
9 Adapter with thread jack [thread 6.3 mm (
for mounting the camera;
to be screwed on the upper or lower side of
the camera
10 Selector switch for adjusting the camera to
the AI lens type used [AI = "auto iris" (auto-
matically controlled iris)]
"VIDEO": for a lens controlled by video signal
"DC": for a DC controlled lens (DC lens)
11 Control for adjusting the video signal level
when using a DC lens
12 Jack for connecting a lens with automatic iris
control (AI lens);
depending on the switch LENS (10), the jack
has the following pin configuration:
2 1
4 3
1
/ ")]
4
➂
Jack AUTO IRIS
GB
11