Preparation - ZUMEX ESSENTIAL BASIC Manuel De L'utilisateur

PREPARATION

To start squeezing you must follow the steps below:
1
Unpack your juicer and place it on a surface as horizontal as possible.
2
Ensure that the mains power falls within the margins indicated on the Identifi-
cation Label of the machine which you will find both on the cover page of this
manual as well as on the machine itself.
3
Place the peel buckets as indicated in Fig. 1 and 4.
4
Make sure that the juice container and its filter are placed correctly and that the
cover is closed and secured by the catch.
ZUMEX ESSENTIAL BASIC. Before starting the unit, place the orange feeding tube in the
position shown on Fig. 2. Use the 4 mm Allen key supplied with the machine
If you have acquired a juicer with a podium, you must place the juicer on the podium,
screw it as indicated in the instruction supplied on the podium. Don't forget to secure
the front wheels. Then place the hopper and the peel buckets with an open base
which you will find inside the stand (Fig. 5).
REMEMBER: Use fruit which does not exceed 81 mm in diameter.
(Between 65 and 78 mm recommended)
If the machine is used for more than 50 minutes, extracting juice with
load, remember that you must leave it for 20 minutes before using it
again.
OPERATION
ESSENTIAL BASIC
Place a glass / jug under the juice outlet and press the green button (Fig. 3). The
machine will start to operate when you press the button. To stop the juicer, press the
red button.
ESSENTIAL PRO Y VERSATILE PRO
Once the previous steps have been followed, connect the connecting plug to a socket base
fitted with a standardized ground. And press the sleeve button to start up the machine.
43