Fault Detection - ZUMEX ESSENTIAL BASIC Manuel De L'utilisateur

DETECTING FAULTS
FAULT
THE MACHINE DOESN'T
WORK
THE MACHINE BLOCKS
FREQUENTLY DURING
JUICING
THE PRESSING UNITS ARE
NOT SYNCHRONIZED
PEEL EJECTOR BREAKS
YOU CAN HEAR THE MOTOR
RUNNING BUT THE PRESSING
UNITS ARE NOT TURNING
THE FAUCET GETS BLOCKED
POSSIBLE CAUSE
Machine not plugged in.
No power is reaching the plug.
Cover not fitted properly.
Juice container not fitted properly.
Blocked pressing units.
Safety sensors malfunctioning.
Faulty ON/OFF button.
Faulty circuit.
Insufficient voltage.
Faulty circuit.
Fault in an axle.
Peel ejector incorrectly fitted.
Internal fault.
The juice has seeds or too much
pulp.
CORRECTION
Plug it in.
Check the socket.
Make sure it has been fit properly.
Make sure it has been fit properly.
Turn off the machine at the mains
and unblock the pressing units.
Contact your technical service.
Contact your technical service.
Contact your technical service.
Check that the voltage matches
that indicated in the manual.
Contact your technical service.
Contact your technical service.
Place it in its correct position
inserting it totally until observing it
has madecontact (Fig. 8)
Contact your technical service.
Disassemble and clean the faucet
according Fig. 11A.