Esoteric K-01XD Mode D'emploi page 29

The unit does not respond when buttons are pressed.
e Multiple button presses without pause can cause the main unit
to stop responding. After pressing a button, wait momentarily
for the main unit to respond.
There is noise.
e Place the unit as far away as possible from TVs and other devices
that have strong magnetism.
No sound is output from the speakers. The sound is distorted.
e Check the connections with the amp and the speakers
(page 10).
e Adjust the volume of the amplifier and other devices.
e If the disc is dirty, wipe it clean (page 8).
e Super Audio CD digital audio cannot be output from the digital
audio output (DIGITAL OUT) connectors.
e No sound is output when playback is paused. Press the play
(7) button to resume ordinary playback.
e Check the analog output setting (page 26).
Digital recording is not possible on connected external
equipment.
e You cannot record the digital audio signal as is from a disc that
has such copy-protection.
Noticeable difference in volume between CDs and Super
Audio CDs.
e You might notice volume differences between ordinary CDs
and Super Audio CDs. This is the result of differences between
their data recording methods, mastering and authoring.
Clock sync
The CLOCK indicator does not stop blinking.
e Set CLK> to OFF when not using clock sync.
e A clock signal to which the unit cannot synchronize might be
being input. Check the connections of the clock connectors
and the settings of connected devices. This unit only supports
10MHz clock.
A cyclical noise is being output.
e If a cyclical noise is being output when the unit is in clock sync
mode, the connected device might not also be in clock sync
mode. Check the connection status of the clock connectors
and the clock settings of the connected device.
USB connections with a computer
Computer does not recognize this unit.
e See page 22 for information about supported operating
systems. Operation with unsupported operating systems is not
guaranteed.
There is noise.
e Starting other applications during playback of an audio file
may interrupt playback or cause noise. Do not start other appli-
cations during playback.
e When the unit is connected to a computer via a USB hub, for
example, noise might be heard. If this occurs, connect the unit
directly to the computer.
Audio files cannot be played back.
e Connect the computer with this unit and switch to "USB in"
before starting the audio playback software and audio file play-
back. Audio data might not play back correctly if you connect
this unit with the computer or change its input to "USB in" after
starting the audio playback software.
Since this unit uses a microcontroller, external noise and other
interference can cause the unit to malfunction. If this occurs,
turn the unit off and wait about one minute before restarting
operation from the beginning.
29