DeWalt DCF887 Guide D'utilisation page 11

6. Move the locking arm back into place, push the tab back
down so the pin engages the locking arm.
Fig. E
15
Fig. F
13
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Belt Hook (Optional Accessory) (Fig. A)

WARNING: Drop Hazard. To reduce the risk of
serious personal injury, DO NOT use the belt hook
for tethering or securing the tool to a person or object
during use when elevated.

WARNING: To reduce the risk of serious personal
injury, DO NOT suspend tool overhead or

14
nOTE: Bit clip and belt hook cannot be used with the
lanyard-ready attachment kit installed.
iMPORTAnT: When attaching or replacing the belt hook,
use only the screw
tighten the screw.
The belt hook
tool using only the screw
or right- handed users. If the hook is not desired at all, it can
be removed from the tool.
To move belt hook, remove the screw
hook in place then reassemble on the opposite side. Be sure
to securely tighten the screw.
OPERATION

Installing and Removing the Battery Pack
(Fig. G)
12
15
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
handle. Insert it into the charger as described in the charger
section of this manual.
Proper Hand Position (Fig. H)


Proper hand position requires one hand on the main
handle
suspend objects from the belt hook. ONLY hang
tool's belt hook from a work belt.
WARNING: To reduce the risk of serious personal
injury, ensure the screw holding the belt hook
is secure.
9 that is provided. Be sure to securely
8 can be be attached to either side of the
provided, to accommodate left-
9
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Fig. G
5 6
6 into the tool handle, align the
5 and firmly pull the battery pack out of the tool
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
.
10
English
9 that holds the belt
9