EINHELL RT-SM 305 L Mode D'emploi D'origine page 19

Anleitung_RT_SM_305_L_Kit_SPK1:_
3. Items supplied (Fig. 1-4)
Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Drag, crosscut and miter saw
Clamping device (8)
Roll base with limit stop (9)
2 x holding bar for the roll base (10)
Chip box (23)
Allen key (O)
Allen key (P)
Original operating instructions
Safety instructions
4. Proper use
The drag, crosscut and miter saw is designed for
cross-cutting wood and wood-type materials which
are appropriate for the machine's size. The saw is not
designed for cutting firewood.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
The machine is to be operated only with suitable saw
blades. It is prohibited to use any type of cutting-off
wheel.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
21.03.2012 10:10 Uhr Seite 19
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about its potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machineʼs construction and
design:
Contact with the saw blade in the uncovered saw
zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of workpieces.
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if essential ear-muffs are not
worn.
Harmful emissions of wood dust when the
machine is used in closed rooms.
5. Technical data
Asynchronous motor
Output
Operating mode
Idle speed n
0
Carbide-tipped saw blade
Number of teeth
Tilting range
Mitre cuts
Sawing width at 90°
Sawing width at 45°
Sawing width at 2 x 45°
(double mitre cuts)
Weight
Laser class
Laser wave length
Laser output
Laser module power supply
GB
230 V~ 50 Hz
1800 W
S1
4800 min -1
ø 210 x ø 30 x 2,8 mm
24/48
-52° / 0°/ +60°
0° to 45° to the left
310 x 65 mm
220 x 65 mm
220 x 35 mm
15 kg
2
650 nm
≤ 1 mW
2 x 1.5 V Micro (AAA)
19