Bosch RIESE & MULLER BDU330 Mode D'emploi page 23

English – 14
EN-40
Start-up
Use only original Bosch batteries that the manu-
u
facturer has approved for your eBike. Using
other batteries can lead to injuries and pose a fire
hazard. Bosch accepts no liability or warranty
claims if other batteries are used.
Switching on/off
Switching on the battery is one way to switch on the
eBike system. Read and follow the instructions in the
operating manuals for the drive unit and on-board
computer.
Before switching on the battery, i.e. the eBike sys-
tem, make sure that the lock (6) is closed.
To switch on the battery, press the on/off button (4).
Do not use sharp or pointed objects to press the but-
ton. The LEDs on the indicator (3) will light up, indi-
cating the battery's state of charge at the same time.
Always check that the battery pack is locked in
u
place. To do this, pull on the battery pack (after the
key has been removed).
Note: If the battery capacity is less than 5 %, none of
the LEDs on the battery charge indicator (3) will light
up. The only way to see if the eBike system is
switched on is via the on-board computer.
To switch off the battery, press the on/off button (4)
again. The LEDs on the indicator (3) go out. This will
also switch the eBike system off.
Always remove the battery pack from the bicy-
u
cle before transporting the bicycle on a vehicle
bike rack. Failure to remove the battery pack when
using a vehicle bike rack can lead to death or seri-
ous injury. The battery may detach during transport
and cause an accident to following vehicles.
Always use an approved and compatible bicycle
u
rack when transporting your eBike. The Bosch
drive system adds weight to the bicycle. Refer to
0 275 U07 XPX | (09.04.2020)
Operation
If no power is drawn from the eBike drive for about
10 minutes (e.g. because the eBike is not moving)
and no button is pressed on the on-board computer
or the operating unit of the eBike, the eBike system,
and therefore also the battery, will switch off auto-
matically to save energy.
The battery is protected against deep discharge,
overloading, overheating and short-circuiting by the
"Electronic Cell Protection (ECP)". In the event of
danger, a protective circuit switches the battery off
automatically.
If a fault is detected in the
battery, two of the LEDs
on the battery charge in-
dicator (3) will flash. Con-
tact an authorized bicycle
dealer if this happens.
Behavior in the event of a fault
The Bosch eBike battery must not be opened, even
for repairs. There is a risk that the Bosch eBike bat-
tery could catch fire, e.g. due to a short circuit. This
risk arises if a Bosch eBike battery which has already
been opened is reused at a later point in time.
Therefore, do not repair the Bosch eBike battery in
the event of a fault, but have it replaced with an origi-
nal Bosch eBike battery by your specialist retailer.
Transport
your bicycle rack manual to be sure your eBike is
compatible. Overloading a bike rack can result in
death or serious injury.
Use proper lifting techniques as electric bikes
u
are generally heavier than bicycles.
Ship batteries only when the housing is undamaged.
Tape or mask off open contacts and pack up the bat-
tery in such a manner that it cannot move around in
the packaging. Inform your parcel service that the
package contains dangerous goods. Please also ob-
serve possibly more detailed national regulations. Al-
ways check state and federal regulations before at-
tempting to ship your battery.
Do not open any of the components. Service
u
should only be carried out at an authorized
Bosch eBike dealer. Failure to follow above warn-
ing can cause death or serious injury. Refer to your
bicycle manual or component manual for all non-
Bosch drive system components.
Always remove the battery pack before per-
u
forming any bicycle inspection, maintenance or
repair. Failure to remove the battery pack before
performing bicycle inspection, maintenance or re-
pair can lead to serious injury.
If replacing your battery, buy only a genuine
u
Bosch battery pack from an approved source.
See your Bosch eBike dealer for original Bosch
parts.
Always switch the battery pack off, when insert-
u
ing or removing it from the holder. Never attempt
to insert or remove the battery pack while riding
the bike.
Do not charge or use your eBike in any area with
u
a potentially explosive atmosphere, such as at a
fueling area, or in areas where the air contains
chemicals or particles (such as grain, dust, or
metal powders). Obey all signs and instructions.
Do not submerge your eBike components in wa-
u
ter, or wash with pressurized hose. Your Bosch
drive unit is designed to be water tight to rain water
or non-pressure hose washing.
The service life of the battery can be extended if it is
looked after well and especially if it is stored at the
correct temperature.
Bosch eBike Systems Bosch eBike Systems
If you have any questions about transporting the bat-
teries, contact an authorized bicycle dealer. You can
also order suitable transport packaging from the
dealer.
Maintenance/cleaning
Note down the manufacturer and the number of
u
the key. In case of loss of the keys, please refer to
an authorised Bosch eBike dealer. Please provide
the name of the manufacturer and the number of
the key.
Do not paint any components of the Bosch drive
u
system as they may cause premature failure of
the component.
After-sales service and advice on using
products
If you have any questions about the eBike system and
its components, contact an authorized bicycle dealer.
For contact details of authorized bike dealerships,
please visit www.bosch-ebike.com.
Please contact an authorized bicycle dealer if the bat-
tery is no longer working.
Cleaning
Do not submerge your eBike components in wa-
u
ter, or wash with pressurized hose. Your Bosch
drive unit is designed to be water tight to rain water
or non-pressure hose washing.
Keep all components of your eBike clean, especially
the battery-pack contacts and corresponding holder
contacts. All components including the drive unit may
not be immersed in water or cleaned with a high-pres-
sure cleaner. Keep all components of your eBike
clean, especially the batterypack contacts and corre-
sponding holder contacts. Clean them carefully with a
soft, damp cloth (using only mild soap and water).
Storing
As it ages, however, the capacity of the battery will di-
minish, even with good care.
English – 15
EN-41
0 275 U07 XPX | (09.04.2020)