Wayscral TAKEAWAY E-200 Notice D'utilisation page 86

After charging for more than
4/5 hours, the
indication LED is still red
(note: it is very important to
charge the battery according
to the instructions to avoid
damaging the equipment).
Troubleshooting charger issues:
•
The red light does not work during charging: check that the
connectors are properly connected. Check that the nominal
voltage is correct; if so, please check the condition of the
charger. If the latter is good, this means the battery is likely to
be defective.
•
The red light does not turn green: turn off the power. After 5
seconds, reconnect the power supply and the charger can
continue to charge. If the battery no longer charges, this means
it is likely to be defective.
•
The red light immediately turns green: check that the battery is
fully charged. If it is not, the battery or charger is faulty.
•
If the fuse has blown: do not disassemble the charger but take
it to a qualified repairer who will replace the fuse with a new
one with the same characteristics (T3.15A/250 V).
1) the ambient temperature is
charge 40°C or higher,
2) the ambient temperature is
0°C or lower,
3) the bicycle
charged after use, which
exacerbated the decrease in
charge,
4) the output voltage is too
low to charge the battery.
1) charge the battery below
40°C and in accordance with
the instructions,
2) charge the battery indoors
was not and in accordance with the
instructions,
3) correctly maintain the
battery to avoid exacerbating
the decrease in charge,
4) do not charge with a
voltage lower than 100 V.
If the above solutions do not
work, contact your retailer or
a qualified professional.
86
EN