Troubleshooting Guide - DeWalt DW713 Guide D'utilisation

TROUBLE! WHAT'S WRONG?
Saw will not start 1. Saw not plugged in
2. Fuse blown or circuit breaker tripped
3. Cord damaged
4. Brushes worn out
Saw makes 1. Dull blade
unsatisfactory cuts
2. Blade mounted backwards
3. Gum or pitch on blade
4. Incorrect blade for work being done
Blade does not come 1. Extension cord too light or too long
up to speed
2. Low house current
Machine vibrates 1. Saw not mounted securely to stand
excessively or work bench
2. Stand or bench on uneven floor
3. Damaged saw blade
Does not make accurate 1. Miter scale not adjusted correctly
miter cuts
2. Blade is not square to fence
3. Blade is not perpendicular to table
4. Workpiece moving
Material pinches blade 1. Cutting bowed material

Troubleshooting Guide

BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
WHAT TO DO
1. Plug in saw.
2. Replace fuse or reset circuit breaker.
3. Have cord replaced by authorized service center.
4. Have brushes replaced by authorized service center or replace them yourself. Refer to Brushes.
1. Replace blade. Refer to Changing or Installing a New Saw Blade.
2. Turn blade around. Refer to Changing or Installing a New Saw Blade.
3. Remove blade and clean with turpentine and coarse steel wool or household oven cleaner.
4. Change the blade type. Refer to Saw Blades under Accessories.
1. Replace with adequate size cord. Refer to Use Proper Extension Cord under Important Safety
Instructions.
2. Contact your electric company.
1. Tighten all mounting hardware. Refer to Bench Mounting.
2. Reposition on flat level surface. Refer to Familiarization.
3. Replace blade. Refer to Changing or Installing a New Saw Blade.
1. Check and adjust. Refer to Miter Scale Adjustment under Adjustments.
2. Check and adjust. Refer to Miter Scale Adjustment under Adjustments.
3. Check and adjust fence. Refer to Bevel Square to Table Adjustment under Adjustments.
4. Clamp workpiece securely to fence or glue 120 grit sandpaper to fence with rubber cement.
1. Refer to Bowed Material under Special Cuts.
15