Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
CAUTION:
When using the tool in the pistol configuration,
do not hold onto the bending portion of the tool
when returning to the straight configuration.
Your finger or other part of the hand may be
pinched by the bending portion resulting in
possible injury (Fig. 13).
THE SCOPE AND SUGGESTIONS FOR USES
Work
Drilling
Steel
Aluminum
Small
screw
Screw
tightening
Wood
screw
CAUTION:
While operating the Cordless driver drill, take care not to lock the motor.
If the motor is locked, immediately turn the power off.
If the motor is locked for a while, the motor or battery will be burnt.
Do not tighten too strongly as the screw heads will be damaged.
MAINTENANCE AND INSPECTION
CAUTION: Pull out battery before doing any inspection or maintenance.
1. Checking the condition of the bit
The bits should be checked regularly. If worn or broken bits can slip or decrease the
efficiency of the motor and burn it out.
Replace worn bits with new ones.
CAUTION: If you use a driver bit of which point is worn or broken, it will be dangerous
since it slips. So replace it with a new one.
2. Check the Screws
Loose screws are dangerous. Regularly inspect them and make sure they are tight.
CAUTION: Using this power tool with loosened screws is extremely dangerous.
3. Check for Dust
Dust may be removed with a soft cloth or a cloth dampened with soapy water.
Do not use bleach, chlorine, gasoline or thinner, for they may damage the plastics.
18
Table 6
Cap position
Use for drilling purpose.
Use the bit and socket matching the screw
1 – 21
diameter.
1 –
Use after drilling a pilot hole.
Bending portion
Fig. 13
Suggestions
Publicité
Table des Matières
