Hitachi DB 3DL Instructions De Sécurité Et Mode D'emploi page 17

Masquer les pouces Voir aussi pour DB 3DL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CAUTION:
The motor rotation may be locked to cease while the unit is used as drill. While operating
the driver drill, take care not to lock the motor.
When setting the shift knob to "HIGH" (high speed) and the position of the clutch dial
is between "9" and "21", it may happen that the clutch does not engaged and that the
motor is locked. In such a case, please set the shift knob to "LOW" (low speed).
If the motor is locked, immediately turn the power off. If the motor is locked for a
while, the motor or battery may be burnt.
Too long hammering may cause the screw broken due to excessive tightening.
8. Switch operation
(1) Lock switch
The tool is equipped with a lock switch. To activate
the main switch lock, move the lock switch to the
"
LOCK" position. Move the lock switch to the
opposite position to operate the tool. (Fig.10)
CAUTION:
Always set the lock switch to the "
position when carrying or storing the tool eliminate
unintentional starting.
(2) Main switch
The main switch functions as a motor switch and
rotational direction selector switch. When the main
switch is pushed to "R" indicated on the main
switch, the bit rotates clockwise. When the main
switch is pushed to "L" indicated on the main
switch, the bit rotates counterclockwise. When the
main switch is released, the tool stops. (Fig. 11)
9. Using the light
The light lights when the light switch is pushed.
When the light switch is pushed again, the light is
turned off. (Fig. 12)
CAUTION:
Do not look directly into the light. Such actions
could result in eye injury.
10. Using in the Straight or Pistol Configuration
Use the tool in the straight configuration when using
in confined spaces. Use it in the pistol configuration
when using in other locations. Select the configuration
that best matches the tool application. When changing
the configuration, the tool will make a clicking sound
when it snaps into position. Bend (or extend) the tool
until the clicking sound is heard.
Lock switch
LOCK"
R
L
English
Unlock
Lock
"
LOCK"
Fig. 10
Main switch
Fig. 11
Light switch
Fig. 12
R
L
17

Publicité

Table des Matières
loading

Table des Matières