Publicité
Les langues disponibles
Les langues disponibles
For flush mounting:
2
According to the figure, create the drill hole Ø 1
/
" (35 mm) for fixing in place the control knob in
3
8
the front side of the lower cabinet. A drilling
template is included for precise positioning of the
drill hole.
For flush mounting:
Installation Procedure
Installing the heat shield
9
CAUTION
Sharp edges. Use protective gloves when
installing the plate.
For safety reasons, the heat shield must be properly
installed. This prevents components from overheating
as a result of the recirculation of hot air from the
cooktop.
The heat shield is the same width as the cooktop. For
shipping, it is screwed to the burner box.
After unpacking the cooktop, unscrew the heat shield.
The heat shield will be able to rotate freely, as shown
in the illustration.
9
Publicité
