Operation; Setup - Titan PowrLiner PL4950 Mode D'emploi

Operation

4. Operation
This equipment produces a fluid stream at extremely
high pressure. Read and understand the warnings
in the Safety Precautions section at the front of this
manual before operating this equipment.
4.1

Setup

1. Make sure the siphon hose (fig. 4, 1) is connected to the fluid
section (2) and the bleed hose (3) is connected to the bleed
valve (4). They each have factory installed PTFE tape on the
male end of the hoses and should be wrench tight.
4
1
2. Install the gun support bar.
i
The spray gun, hose, and cables are mounted to the
gun support bar at the factory.
a. Loosen the support bar clamps on each side of the cart.
b. Slide the gun support bar through the cart.
c. Tighten the support bar clamps to secure the gun support bar
in position.
i
The gun support bar and the spray gun(s) can be
mounted on either side of the sprayer.
3. Position the first spray gun.
a. Disengage the trigger cable from the tensioning clamp.
Always disengage the trigger cable from the
tensioning clamp before making any adjustments to
the spray gun position.
Attention
b. Loosen the support bar clamps and slide the gun support bar
to the desired horizontal position.
c. Loosen the gun riser clamp and slide the spray gun to the
desired vertical position.
The height of the spray gun affects the width of the
i
spray pattern (i.e., the lower the gun, the smaller the
line width). Tip size also affects line width.
4. Install the second gun assembly, if desired. Refer to the
installation instructions for the second gun assembly in the
Spare Parts List section of this manual (p. 100/101).
5. Set the trigger selector for proper spray gun operation. The
right handlebar triggers the gun or guns. The selector on the
trigger must be set for the first gun, both guns, or the second
gun .
2
3
GB
Always turn the trigger lock on the spray gun to the
locked position before making any adjustments to
the trigger selector. Also, release the trigger cable
from its block by lifting the cable up and out of the
Attention
block. There will be a brief triggering of the gun
while releasing the trigger cable.
First Gun — The first gun position is with the selector in the
a.
left position. Push the lever toward the inside of the frame until
the pin engages the left plate.
b. Both Guns — The dual gun position is with the selector in the
center position. Push the lever toward the center position until
the pin engages both plates. The pin must engage both plates.
Second Gun — The second gun position is with the selector in
c.
the right position. Push the lever away from the inside of the
frame until the pin engages the right plate.
A
6. Fill the oil cup 1/2 full with Piston Lube (P/N 314-480). This
extends packing life.
Piston Lube prevents increased wear and tear to the
packings.
Attention
7. Check the hydraulic fluid level daily before starting the
sprayer. The hydraulic fluid level should be at the "Full" mark
on the dipstick. Refer to the Maintenance section of this
manual for hydraulic system maintenance instructions.
use of Titan's Coolflo™ Hydraulic Fluid (P/N 430-361)
is mandatory in the hydraulic system. Do not use
any other hydraulic fluid. use of any other hydraulic
fluid may seriously damage the hydraulic system
Attention
and will void the warranty.
8. For gas models, check the engine oil level daily before starting
the sprayer. The gasoline engine oil level is determined by
the engine manufacturer. Refer to the engine manufacturer's
service manual supplied with this sprayer.
8
B C
PowrLiner