ESAB Powercut 875 Manuel D'instruction page 77

sEctIoN 3
Allow at least 10 ft. (3m)
between work and power source
WORK
SAFETY GROUND
ACCESS FOR CNC INTERFACE CONNECTIONS.
(See Detail "A")
PT-32EH
CUSTOMER FUSED LINE DISCONNECT SWITCH
(See Table 2.1 and WARNING in regards to chassis
ground in Section 3.5.)
Prefiltered AIR SUPPLY
(Customer Supplied)
6.2 to 10.3 bar
(90 to 150 psig max)
figure 3-1. powercut 875 Interconnection Diagram
Use a Brass 45
Female x 6.4mm (1/4") NPT male street
elbow for better clearance around the handle.
INPUT POWER CABLE
(See Table 3.1)
77
INstallatIoN
ACCESS COVER FOR
TORCH CONNECTION
6.4mm (1/4") NPT
°