ESAB Powercut 875 Manuel D'instruction page 2

according to the Low Voltage Directive 2006/95/EC, according to the EMC Directive 2004/108/EC
enligt Lågspänningsdirektivet 2006/95/EG, enligt EMC-Direktivet 2004/108/EG
Type of equipment Materialslag
Plasma Cutting Console
Brand name or trade mark Fabrikatnamn eller varumärke
ESAB
Type designation etc. Typbeteckning etc.
PowerCut (PC) 875, (0558004939, 0558004941) & Torch PT-32EH, (0558003548, 0558003549)
Manufacturer or his authorised representative established within the EEA
Name, address, telephone No, telefax No: Tillverkarens namn, adress, telefon, telefax:
ESAB AB
Esabvägen, SE-695 81 Laxå, Sweden
Phone: +46 586 81000, Fax: +46 584 411 924
The following harmonised standard in force within the EEA has been used in the design:
Följande harmoniserande standarder har använts i konstruktionen:
EN 60974-1, Arc welding equipment – Part 1: Welding power sources
EN 60974-10, Arc welding equipment – Part 10: Electromagnetic compatibility (EMC) requirements
Additional information: / Tilläggsinformation: Restrictive use, Class A equipment, intended for use in locations other than
residential
By signing this document, the undersigned declares as manufacturer, or the manufacturer's authorised
representative established within the EEA, that the equipment in question complies with the safety requirements
stated above.
Genom att underteckna detta dokument försäkrar undertecknad såsom tillverkare, eller tillverkarens representant inom
EES, att angiven materiel uppfyller säkerhetskraven angivna ovan.
Date / Datum
Laxå 2007-12-20
DECLARATION OF CONFORMITY
FÖRSÄKRAN OM ÖVERENSSTÄMMELSE
Signature / Underskrift
Kent Eimbrodt
Clarification
2
Position / Befattning
Global Director
Equipment and Automation