ESAB Powercut 875 Manuel D'instruction page 206

sectIon 5
5.3 pt-32 torch consumaBle parts
To assemble the consumable parts, refer to Figure 5-1.
A. Place nozzle, swirl baffle, electrode, and valve pin into the shield as shown.
B. Thread assembly to the torch body and hand tighten. always make sure the shield is very tight before cutting.
warnInG
warnInG
* VALVE PIN
ELECTRODE
NOZZLE
SHIELD
make shIeld Very tIGht!
*
The valve pin is a crucial member of the system. Its function is to open the gas flow check valve that
is permanently assembled within the torch head. If the pin is not correctly placed in the electrode,
the valve will not open and the system will not function. The valve pin also improves electrode
cooling by increasing the velocity of air over the inner surface of the electrode.
make sure power swItch on powercut 875 Is In off posI-
tIon Before workInG on the torch.
the pt-32 torch head contaIns a Gas flow check ValVe that
acts In conjunctIon wIth the flow swItch and cIrcuItry
wIthIn the power source. thIs system preVents the torch
from BeInG enerGIzed wIth hIGh VoltaGe If the torch swItch
Is accIdentally closed when the shIeld Is remoVed. always
replace torch wIth the proper torch manufactured By
esaB sInce It alone contaIns esaB¹s patented safety Inter-
lock.
PLACE THE VALVE PIN INTO THE ELECTRODE AND
SCREW THE ELECTRODE INTO THE TORCH HEAD
AND TIGHTEN SECURELY WITH WRENCH #19120.
PLACE NOZZLE INTO HEAT
SHIELD AND THREAD
THIS ASSEMBLY TO THE
TORCH BODY AND HAND
TIGHTEN.
Important!
figure 5-1. assembly of pt-32 torch front end parts
1
2
206
maIntenance
3