Display Status Bar; Prepare The Doppler For Use; Battery Insertion / Replacement; Probe Connection - arjo HUNTLEIGH SR Série Mode D'emploi

4.3

Display Status Bar

Status Bar Icons
Battery Level Low
USB Connected
USB Receiving
Standard Mode - FHR outside
user set range
Smooth Mode - FHR outside
user set range
Manual Mode
5.

Prepare the Doppler for Use

5.1

Battery Insertion / Replacement

Disconnect the Doppler from any other equipment before removing the battery cover.
Insert a suitable tool into the recess, release the
clip and gently lever off the battery cover.
• Use either alkaline LR6 (non-rechargeable) or NiMH HR6 (rechargeable) batteries.
• Do not mix rechargeable and non-rechargeable batteries.
Note: If the Doppler will not be used for an extended period, remove the batteries.
5.2

Probe Connection

To connect the probe to the SRX Doppler, align the arrow on the connector with the slot on the probe and push
together fi rmly. (Doppler models SR2 and SR3 have captive probes).
To disconnect the probe, pull the connector from the probe. DO NOT pull the cable.
The Status Bar appears at the top of most screens, the
information displayed depends on the operating mode.
Date / Time
27/01/2015 14.30
USB Transmitting
Signal Strength
Standard Mode - FHR within user set
range
Smooth Mode - FHR within user set
range
Insert the batteries according to the diagram,
observing polarity.
EN