Characteristics - Faro SK07 Mode D'emploi

CHARACTERISTICS

THE DEVICE IS DESIGNED TO STERILIZE USING WET SATURATED STEAM.
The vacuum pump enables an optimal process of sterilization to be achieved with a correct
interaction between the steam and the processed load, even in the cavities.
STERILIZATION PROGRAMMES
- 121°C or 134°C
- 134°C
- 134°C B Flash
TEST PROGRAMMES
- Vacuum leak test:
- Bowie & Dick test:
- Helix test121°C
- Helix test134°C:
AUTOMATIC LAST ADVANCED CYCLE OPERATION
At the end of the cycle, with the door closed, the autoclave goes into standby after 30 minutes.
Furthermore, when the temperature in the chamber reaches 60° C, the drying phase is repeated.
WATER FILLING SYSTEMS
Automatic: with the aid of a pump found inside the autoclave.
Manual: alternatively the device is equipped with a manual fi lling system.
Possibility of connecting a demineralizing system to increase the length of operating time.
AUTOMATIC CONTROL OF THE STERILIZATION PARAMETERS
The parameters of pressure, temperature and time are continuously monitored during the
sterilization phase by means of an automatic control system.
BIO-X FILTER
Inputs sterile air into the chamber during the drying phase and in the pressure balance phase.
USB CONNECTION
A computer can be connected to monitor machine operation and set the parameters (this must
be done by an authorized technician).
LCD
A menu system ensures complete management of the autoclave.
cycle type B standard
cycle type B Prion
cycle type B fast
tests the ability to maintain the vacuum
tests steam penetration in the porous load
tests steam penetration in hollow loads
25 25