Vitalmaxx ZJ1002 Mode D'emploi page 30

EN
Step 3
1 x no. 29 Ø 8 x 60
1 x no. 18 M 8 x 45
1 x no. 22 M 8
Step 4
00162_de-en-fr-nl_V3.indb 30 00162_de-en-fr-nl_V3.indb 30
30
1. Insert the end of the perforated
tube (4) in the connecting piece on
the front support foot.
2. Insert the short bolt (29) through the
holes in the middle of the connecting
piece and the holes on the perforated
tube.
• If you would like to pull the bolt back
out, push the catch on the bolt.
3. Screw the nut (22) off of the
screw (18). Leave the washer on the
screw.
4. Insert the screw into the holes (in the
corner) of the connecting piece and
perforated tube.
5. Screw the nut onto the screw and use
the enclosed Allen wrench (32) and
spanner (33) to tighten it.
• Insert the two handles in the openings
on the side of the leg supports. Turn
them back and forth somewhat until
they audibly lock into place.
• If you would like to pull a handle back
out, push the leg support pad back a
bit and push the catch.
29.05.2017 14:18:21 29.05.2017 14:18:21