Step 1
1 x no. 31 Ø 8 x 80
Step 2
1 x no. 30 Ø 8 x 60
00162_de-en-fr-nl_V3.indb 29
00162_de-en-fr-nl_V3.indb 29
29
1. Fold out the back rest with seat and
rear support foot.
2. Insert the long bolt (31) through the
holes on the connecting piece and
the back rest frame. If necessary, the
connecting piece between the back
rest and the connecting tube (8) must
be pushed a little bit towards the back
rest frame so that the bolt can be run
through it.
•
If you would like to pull the bolt back
out, push the catch on the bolt.
•
Insert the medium bolt (30) through
the holes of the connecting piece and
the tube (3) which the seat is mounted
on. If applicable, lift the tube slightly
so that the bolt can be run through it.
•
If you would like to pull the bolt back
out, push the catch on the bolt.
EN
29.05.2017 14:18:20
29.05.2017 14:18:20