Enabling The E-Source In The Heat Pump Or Cascade Of Heat Pumps; Plan Communication Cable Connection; Source Manager Configuration; Final Inspection And Commissioning - ECOFOREST ecoSMART e-manager Manuel D'utilisation

If the control panel shows no image for more than 10 seconds when starting configuration, repeat the configuration step by step. If
this persists, check that the right e-source manager software is loaded.

7.3. Enabling the e-source in the heat pump or cascade of heat pumps

If not done already, configure the heat pump or cascade of heat pumps, depending on the characteristics of your installation.
Enable the "Source Manager" in the heat pump or in the supervisor module in the installer menu → Configuration → Brine →
Source manager.
→
Figure 7.2. Screen to enable use of the e-source manager in the heat pump or in the cascade supervisor.

7.4. pLAN communication cable connection

Connect the pLAN communication cable to the e-source manager.

7.5. Source manager configuration

Configure the source manager in accordance with sections 5 and 6.

7.6. Final inspection and commissioning


Commissioning should be performed only after verification that all the circuits have been properly
filled and bled.
NOTE

Before commissioning, check that all the pumps, valves and other components are functioning
correctly. To do this, you can enable them individually in the installer menu → manual activation of
components.

Before commissioning, check that all the circuits are flowing and that nothing is preventing the flow.
Check the following points to ensure that they have been carried out successfully.
Inspection of the electrical installation:
1. The power supply has been connected to the terminal block of the e-source manager in accordance with the instructions
in section 4.2.
ecoSMART e-source
user, installer and technical service manual
→
63