Maintenance - ECOFOREST ecoSMART e-manager Manuel D'utilisation

Installation and subsequent interventions on the hydraulic circuits controlled by the e-source manager must be performed only by
an authorised technician in accordance with applicable local regulations and the instructions provided in this manual.

Do not touch the pipes while the unit is in operation or immediately after, as this may result in burns
caused by cold or heat. If these components need to be touched, allow sufficient time for the
DANGER!
temperatures to stabilise and wear protective gloves to avoid injury.
Electrical system
Any intervention on the electrical system must only be performed by an authorised electrician in accordance with applicable local
regulations and the instructions provided in this manual.

The power supply to the unit must have an external switch that can shut off all the circuits. Ecoforest
recommends installing an automatic external switch for each of the electrical power sources (power
DANGER!
supply of the e-source manager and power supply of devices controlled by its DO digital outputs).

Please note that the unit may have more than one electrical power source.

Before performing any operation on the unit, disconnect the power supply.

During installation and maintenance of the unit, never leave the cover open unattended.

Do not touch any electrical component with wet hands, as this could cause an electric shock.
Scrapping
The e-source manager is made from a variety of materials and must therefore be delivered to an authorised centre for proper
scrapping and recycling of said materials.

1.2. Maintenance

The e-source no manager does not require any specific maintenance after commissioning. The internal controller constantly
monitors a large variety of parameters and will alert you if any problem or incident occurs, in which case we recommend that you
contact your dealer.

All maintenance work must be performed by an authorised technician. Improper handling of the
equipment as a whole can result in personal injury and/or damage to materials.
DANGER!

Do not spill water or other liquids directly on the casing or inside it, as this could cause an electric
shock or fire.
ecoSMART e-source
user, installer and technical service manual
39