Fitting And Removing The Cover; Location And Assembly - ECOFOREST ecoSMART e-manager Manuel D'utilisation

3.4. Fitting and removing the cover

A 4 mm Allen wrench is required to assemble and disassemble the cover. Remove the front cover by loosening the four screws and
pulling it.

When removing the cover, take care to remove the control panel cable without damaging it.
NOTE

3.5. Location and assembly

Choose a dry place where there is no risk of frost. The e-source manager module must be installed on a stable wall that can support
the full weight of the unit. Use a spirit level to ensure that it is completely horizontal.
Figure 3.2. Removing the front cover of the e-source manager.
Figure 3.3. Positioning the e-source manager.
41
ecoSMART e-source
user, installer and technical service manual