Plan Address - ECOFOREST ecoSMART e-manager Manuel D'utilisation

7.2. pLAN address

The e-source manager pLAN communication address is 14. The pLAN communication address of its control panel must therefore be
19. It is not possible to use other addresses for the e-source manager and its control panel.
Heat pump no. 1
Heat pump no. 2
Heat pump no. 3
Heat pump no. 4
Heat pump no. 5
Heat pump no. 6
ecoSMART e_Source
ecoSMART Supervisor
Table 7.1. Control addresses and control panel addresses for units connected via the pLAN network.
To configure these addresses in the control panel, access the "DISPLAY ADDRESS SETTING" menu by simultaneously pressing and
holding the three buttons on the right of the control panel [↑+ *←┘+ *↓+.
Go back to the "DISPLAY ADDRESS SETTING" menu by simultaneously pressing and holding the three buttons on the right of the
panel [↑+ *←┘+ *↓+. Make sure that "Display address setting" and "I/0 Board address" are correctly selected. Move on from this
screen by pressing *←┘+.
Controller address
Unit
"I/O boardaddress:"
1
2
3
4
5
6
14
15
Change "Display address setting" and "I/0 Board address" to configure the e-source
addresses.
After making the changes, the screen shown in the figure appears. The control panel then
appears with no image.
A screen will appear as shown in the figure. Press *←┘+ to go to the next screen.
In "Trm1" change the control panel address again as shown in the figure.
Press *←┘+ again and change the control panel privacy "Pr". Press *←┘+ until reaching
"No", which is next to "Ok?" and change it to "Yes". Press *←┘+ to start control panel
address configuration.
62
ecoSMART e-source
user, installer and technical service manual
Control panel address
"Displayaddresssetting"
32
31
30
29
28
27
19
18