Hangar 9 P-51D Mustang 20cc Manuel D'utilisation page 21

99. Secure the receiver in the fuselage using hook and loop tape
and straps. Connect four 9-inch (230mm) extensions for the
ailerons and fl aps, and the lead included with the retracts (if
retracts have been installed). Connect the rudder, elevator
and switch as well.
 Make sure the receiver is securely installed if using
an AS3X-equipped item. Read the instructions included
with the receiver for additional mounting details.
100. Locate the remote receiver(s) based on the instructions
included with the receiver or radio system. The remote
receiver(s) was placed as shown.
101. Remove the tray from the fuselage by removing the four
screws using a #1 Phillips screwdriver.
102. Secure the battery in the fuselage using hook and loop tape
and hook and loop straps. The position of the battery can be
adjusted to fi t additional components under the tray or to
balance the model.
P-51D Mustang 20cc
103. Remove the covering from the fuselage side using a hobby
knife and #11 blade. Mount the switch using the hardware
provided with the switch.
 It may be necessary to enlarge the opening
to fit larger switches in the fuselage.
 STABILIZER INSTALLATION
104. Hinge the elevators to the stabilizer. The silver control horns
are also be installed. Follow the procedure outlined earlier for
the aileron hinges and control horns.
105. Us a hobby knife and #11 blade to remove the covering from
the stabilizer opening at the rear of the fuselage.
106. Use a razor saw to remove the portion of the fi n post from the
fuselage.
107. Use medium grit sandpaper to lightly sand the area so
none of the tail post will interfere with the installation of the
stabilizer.
21 EN