Scheduled Assistance - Astoria Plus4You Manuel D'utilisation

Cleaning
STEAM NOZZLE - MILK FOAMER -
AUTOSTEAMER
Check and clean the terminals of the steam
nozzles, using a small needle to reopen the exit
holes.
Clean the inside of the nozzle at least once a
week:
dip the nozzle into a jug of water mixed with
a specific cleaner according to the manufac-
turer's instructions;
heat the solution with the steam of the nozzle;
keep the nozzle immersed in the solution for
at least 5 minutes so as to allow the cleaner
to rise up into the nozzle as a result the cool-
ing effect;
repeat the operation 2 or 3 times so that sub-
sequent dispensing don't leave milk residue.
BODY
Clean the panels of the body with a cloth
dampened in lukewarm water. Do not use abra-
sive detergents which may scratch the surface
of the body.
Remove the tray and the cup holder grille and
wash with hot water. During the cleaning
operations, pay attention to the edges and
protruding parts
DISPENSING UNIT
Carry out the washing of the groups as indi-
cated in Chapter "Group washing" and follow
the instructions below:
use the blind filter holder;
pour the detergent on the solid filter and at-
tach the filter holder;
Carry out a series of dispensing until the water
comes out clean;
remove the filter holder from the unit and
carry out at least one delivery so as to elimi-
nate any detergent residues.
GRINDER-DOSER
Clean the inside and outside of the receptacle
and doser of the grinder-doser with a cloth
dampened in lukewarm water.
52
!
X

16.3 Scheduled assistance

This function is related to the request for ma-
chine assistance and provides notification of when
to proceed with ordinary scheduled maintenance.
X
The request for assistance appears when the
number of coffee, tea, boiler filling cycles, or the
number of days passed since installation of the
machine, have reached a value equal to the cycle
programmed by the technician.
All alarm messages will remain on the display
and blink 10 seconds every minute in the selection
standby phase or in the programming standby
phase.
X
The alarms for reached/exceeded thresholds do
not prevent the machine from functioning.
The alarms can be reset at any time (also before
the alarm is engaged) by a technician.
When the machine is functioning, the system
increases both the machine cycle counter and the
X
time since installation counter.
When the number of executed cycles is less than
1000 cycles in respect to the programmed thresh-
old "A", the alarm message in the example on the
side appears.
When cleaning, always use cloths that are comple-
tely clean and hygienic.To guarantee the correct
operation and hygiene of the machine, it is neces-
sary to use cleaning methods and products suitable
for the purpose. Do not immerge the machine into
water. Never use alkaline detergents, solvents,
alcohol or aggressive substances. The descaling of
the machine has to be performed by specialized
technicians, by disassembling the components
with deposits, so that no descaling debris is put into
circulation. The used products/detergents have to
be suitable for this purpose and must not corrode
the materials of the hydraulic circuits
Cleaning operations should not be carried out by
children without supervision.
Do not spill any liquids or use direct water jets on
the machine.
PLANNED SERVICE -A-
REMAIN CYCLES 0999
PLEASE CALL SERVICE
User manual