Metal Filter; Paper Filter (Hepa); Motor Protection Filter; Exhaust Air Filter - SilverCrest SHAZ 22.2 A1 Mode D'emploi

__CPE284657_Staubsauger_B6.book Seite 12 Montag, 12. Dezember 2016 8:29 20

9.2 Metal filter

The metal filter 11 is lo-
7
cated at the end of the
filter carrier 7. With a
slight twist, the metal fil-
ter 11 can be released
and put on again.
11
• To release, rotate the metal filter 11 in
the direction of the open lock symbol
.
• When assembling, rotate the metal fil-
ter 11 in the direction of the closed lock
symbol . Ensure that the metal filter 11
clicks firmly into place.

9.3 Paper filter (HEPA)

The paper filter 6 is located at the upper end
of the filter carrier 7.
• Release the paper filter 6 with a slight
twist before pulling it off.
• When inserting the
6
filter, ensure the posi-
tion of the small later-
al pins at the paper
7
filter 6. They must fit
into the openings of
the filter carrier 7.
Then, lock the paper
filter 6 again.
12 GB

9.4 Motor protection filter

Between the dust con-
5
tainer 10 and the suc-
tion device 5 the motor
protection filter 12 is lo-
cated.
• Remove the dust con-
tainer 10 from the
suction device 5.
12
Then, you can re-
move the motor pro-
tection filter 12 from
the inside of the suc-
tion device 5.

9.5 Exhaust air filter

There are two exhaust
3
air filters 2 at the sides
of the suction device 5.
• To remove the filters,
press the unlocking
mechanism 3 at the
filter cover 4. Then,
you can remove the
2 4
exhaust air filter 2
from the filter cov-
er 4.