Risk Of Injury From Pressurised Components; Risk Of Scalding Due To An Uncontrolled Escape Of Hot Fluids; Risk Of Burns Due To Hot Components And Surfaces; Risk Of Injury In Case Of Improper Work - oventrop Multidis SF Notice D'utilisation

"Multidis SF"
The user has to be informed by the qualified
tradesman as to the operation.
2.6.2 Risk of injury from pressurised
components
f Before starting work, make sure that the
system is depressurised.
f The permissible operating pressures must
be observed during operation.
2.6.3 Risk of scalding due to an
uncontrolled escape of hot fluids
f Before starting work on the heating/cooling
circuit, make sure that the system is
depressurised.
f After all work has been completed, check
the product for tightness.
f Wear safety goggles.
2.6.4 Risk of burns due to hot
components and surfaces
f Before starting work, let the product cool
down.
f Wear protective clothing to avoid
unprotected contact with hot system
components.
2.6.5 Risk of injury in case of improper
work
Stored energies, angular components points
and edges at the outside and inside of the
product may cause injuries.
f Before starting work, make sure that there
is enough space.
f Open and hard-edged components are to
be handled with care.
f Make sure that the work place is tidy and
clean to avoid accidents.
2.6.6 Availability of the operating
instructions
These operating instructions and all other valid
documents (e.g. accessory manuals) have to
be read and applied by any person working on
the product.
The operating instructions have to be kept at
the installation location.
f Hand these operating instructions and
all other valid documents (e.g. accessory
140635280-V01.07.2018
Safety-related information
manuals) over to the user.
EN
19