Warnings; Safety Notes; Danger Due To Insufficient Personnel Qualification; Risk Of Injury From Pressurised Components - oventrop Multidis SFQ Notice D'utilisation

Multidis SFQ
Safety-related information
2.2

Warnings

Each warning contains the following elements:
Warning symbol
SIGNAL WORD
Type and source of danger!
Possible consequences if the danger occurs
or the warning is ignored.
!
Ways to avoid the danger.
Signal words define the severity of the danger
posed by a situation.
NOTICE
Indicates a situation that can potentially
result in damage to property if not avoided.
2.3

Safety notes

We have developed this product in accordance
with current safety requirements.
Please observe the following notes concerning
safe use�
2.3.1 Danger due to insufficient personnel
qualification
Work on this product may only be carried out
by suitably qualified specialist tradespeople.
Due to their professional training and
experience as well as knowledge of the
relevant legal regulations, qualified specialist
tradespeople are able to carry out work on the
described product in a professional manner.
Operator
The operator must be instructed in the
operation by specialist tradespeople.
2.3.2 Risk of injury from pressurised
components
f
Only carry out work when the system is
depressurised.
f
Observe the permissible operating
pressures during operation.
18
2.3.3 Risk of burns due to an uncontrolled
discharge of hot media
f
Only carry out work on the heating/cooling
circuit when the system is depressurised.
f
Check that the product is not leaking after
work is complete.
f
Wear safety goggles.
2.3.4 Risk of burns due to hot components
and surfaces
f
Allow the product to cool down before
working on it.
f
Wear suitable protective clothing to avoid
unprotected contact with hot system
components and fittings.
2.3.5 Risk of injury in case of improper
work
Stored energy, angular components, points
and corners on and in the product can cause
injuries.
f
Ensure that there is sufficient space before
starting work.
f
Handle open or hard-edged components
with care.
f
Keep the work area tidy and clean to avoid
sources of accidents.
2.3.6 Availability of the operating
instructions
Every person who works with this product
must have read and applied this manual and
all applicable instructions.
The instructions must be available at the place
of use of the product.
!
Pass on these instructions and all
applicable instructions to the operator.
140495282-V01.09.2021