Dometic TEC 29 Notice D'utilisation page 16

Technical description
Control elements in the control panel
The control panel is located on the generator behind the cover.
No. in
fig. 2, Description
page 4
1 Main switch
2 TEC29 only: Cut-out
switch
3 TEC29LPG only:
Main fuse
4 TEC29LPG only:
Battery charger fuse
Control elements in the remote control
The remote control is installed in the vehicle interior.
No. in
fig. 3, Description
page 4
1 Display
2 On/Off switch P
3 START button
4 TEC29 only:
Petrol gauge
5 Oil gauge
16
Switches the generator to standby or no
function.
Electromechanical protection against
overload.
Triggers if the AC voltage overloads.
Fuse needs to be replaced if it has
triggered.
Triggers if the AC voltage overloads.
Fuse needs to be replaced if it has
triggered.
Shows the status reports.
Switches the remote control on and off if
the main switch is at "I" or "1".
Stops the generator.
Starts the generator if the remote control
is switched on and the main switch is at
"I" or "1".
Lights up if the petrol goes into reserve.
Lights up if the oil level is too low in the
engine.
TEC29, TEC29LPG
EN