Bandwidth Select (Only For Canada Models); Time-Out Timer; Power Select; Call Tones - Motorola RM Série Guide De L'utilisateur

Bandwidth Select (Only for Canada models)

All US models are compliant with the
narrowbandwidth FCC regulation.
Default setting for Bandwidth Select depends
on the specific frequency and channel. Some
frequencies have selectable channel spacing,
which must match with other radios for
optimum audio quality.
For details, refer to Frequency and Code
Charts section.

Time-Out Timer

When pressing the PTT button, transmissions
can be terminated by setting up a 'time-out'
timer.

Power Select

Power Select allows you to select between
high and low transmission power per frequency
in each channel. The power levels for RM
Series 2W toggle between 1W and 2W.
Note: Some frequencies may have FCC transmit
power restrictions that do not allow them to
be set at a higher power level. For details
see the Frequencies and Code Chart
Section.

Call Tones

Call Tones feature allows you to transmit an
audible tone to other radios on the same
channel to alert them that you are about to talk
or to alert them without speaking.
To use this feature, the Call Tones must be
programmed to either SB1 or SB2 and 1 of the
3 pre-recorded tones is selected.

Scramble

The Scramble feature makes transmissions
sound garbled to anyone listening without the
same code. Scramble default value is OFF. To
change the scramble code during radio's
normal operation, the Scramble feature must
be programmed to either SB1 or SB2.
41
English