Important Safety Information; Industry Canada Wlan Statement - Motorola WAVE TLK 150 Mode D'emploi

For country code selection usage (WLAN devices)
NOTE: The country code selection is for non-US model only and is not available to all US
models. Per FCC regulation, all Wi-Fi products marketed in the US must be fixed to US
operation channels only.
Wireless Device Country Approvals Regulatory markings, subject to certification, are applied to the
device signifying that the radio(s) is/are approved for use in the US. Operation of the device without
regulatory approval is illegal.

Important Safety Information

ATTENTION!
This device is designed to meet General Population usage. Before using the device, read the RF
Energy Exposure and Product Safety Guide that comes with the device. This guide contains operating
instructions for safe usage, RF energy awareness, and control for Compliance with applicable
standards and Regulations.
Any modification to this device, not expressly authorized by Motorola Solutions, may void the user's
authority to operate this device.
For Japan, the device is restricted to indoor use only when operating in the 5150 to 5350 MHz
frequency range, except for transmission with 5.2 GHz High Power Data Communication System base
Station or Relay Station.
Under Industry Canada regulations, this device transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential device interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
This device transmitter has been approved by Industry Canada to operate with Motorola Solutions-
approved antenna with the maximum permissible gain and required antenna impedance for each
antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum
gain indicated for that type, are strictly prohibited for use with this device.

Industry Canada WLAN Statement

CAUTION:
1 The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems.
2 The maximum antenna gain permitted for devices in the bands 5250–5350 MHz and 5470–
5725 MHz shall be such that the equipment still complies with the e.i.r.p. limit.
3 The maximum antenna gain permitted for devices in the band 5752–5850 MHz shall be
such that the equipment still complies with e.i.r.p. limits specified for point-to-point and
non-point-to-point operation as appropriate.
4 The worst case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask
requirement set forth in Section 6.2.2 (3) shall be clearly indicated.
5 User should also be advised that high-power radars are allocated as primary users (i.e.
priority users) of the bands 5250–5350 MHz and 5650–5850 MHz and that these radars
could cause interference and/or damage to LE-LAN devices.
MN006371A01-AF
Legal and Support
7