Cloning With A Multi Unit Charger (Muc) - Motorola RM Série Guide De L'utilisateur

Cloning with a Multi Unit Charger (MUC)

Pocket 1
"CLONE" symbol Pocket 2
To clone radios using the MUC, there must be
at least two radios:
• a Source radio (radio which profiles will be cloned
or copied from) and
• a Target radio (the radio which profile will be
cloned from the source radio.)
The Source radio has to be in Pocket 1 or 4
while the Target radio has to be in Pocket 2 or
5, matching in the MUCs pockets by pairs as
follows:
• 1 and 2 or,
Pocket 4
"CLONE" symbol Pocket 5
• 4 and 5.
When cloning, the MUC does not need to be
plugged into a power source, but ALL radios
require charged batteries.
1. Turn ON the Target radio and place it into one of
the MUC Target Pockets
2. Power the Source radio following the sequence
below:
• Press the PTT button and SB2
simultaneously while turning the radio
ON.
• Wait for 3 seconds before releasing the
buttons until the audible tone "Cloning" is
heard.
3. Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1.
Press and release the SB1 button.
4. After cloning is completed, the Source radio will
announce either "successful" (cloning is
successful) or "fail" (cloning has failed). If the
Source radio is a display model, it will either
43
English