Example Of Programming Active Channels; Other Programming Features; Scan - Motorola RM Série Guide De L'utilisateur

Example of Programming Active Channels

Active Channels is the last Programming
Mode. It allows you to modify the number of
active channels the radio is programmed to
support.
To set Active Channels:
• Enter Advanced Configuration Mode and select
the desired channel.
• Short press the PTT button four times to enter the
Active Channels Programming Selection Mode.
The audible voice in the radio announces "Active
Channels" and the current value.
• Short press the SB1 or SB2 button until you the
number of channels desired.
• Long press the PTT Button. LED Indicator shows
a green heartbeat to indicate 'Idle' Programming
Mode.
• Long press the PTT Button to exit Programming
Mode or turn OFF the radio.
38
English

OTHER PROGRAMMING FEATURES

Scan

Scan allows you to monitor other channels to
detect conversations. When the radio detects a
transmission, it stops scanning and goes to the
active channel. This allows you to listen and
talk to people in that channel without having to
change channel manually. If there are
transmissions on another channel, you will not
hear that activity once the radio has stopped
scanning. Once the activity on transmitting
channel stops, the radio waits for 5 seconds
before resuming scan again.
• To start scanning, press the SB1 or SB2 button
Note: Scan has to be programmed either to SB1
or SB2 button via CPS. SB2 is by default
Down Button for RMU2040/RMU2043/
RMM2050 models.
• To stop scanning, short press the SB1 or SB2
button (programmed for scan) again.
• By pressing the PTT button while the radio is
scanning, the radio will transmit on the channel