How To Operate The Audio Control; Switching Audio Control Modes - Fujitsu Ten Eclipse CD7000 Manuel D'utilisation

How to operate the AUDIO CONTROL

Switching audio control modes

Various audio control modes may be fine-tuned using this procedure.
Press the [ENTER] button for less than one second to select the item to be
1
adjusted.
Modes will switch in the order shown below each time the button is pressed.
3-Way Speaker Layout:
BASS o MIDDLE o TREBLE o SVC*
2-Way Speaker Layout:
2
BAL/FAD* o NON-F*
*1: Setting cannot be made in FM mode.
*2: Setting cannot be made when CSII is set to Low or High.
*3: NON-F (non-fader) Output is not affected by the settings of the BASS, MID and
TREBLE.
ATTENTION
See page 75 for more information on Speaker Layout settings
WARNING
Do not adjust the volume or other controls while driving the vehicle. Do so only while parked in a
safe location.
Mode
BASS Adjusts bass level.
MIDDLE Adjusts middle level.
TREBLE Adjusts treble level.
Adjusts different volume levels for
each audio mode. When SVC is set,
SVC the volume level can changes as
shown in the example setting (See
next page).
BAL/FAD
Adjust left/right (BALANCE) and
(FADER/
front/rear (FADER) speaker balance.
BALANCE)
1
o BASS MMM
2 1
o SVC* o BAL/FAD MMM
Function
Upper
Emphasizes
low sounds.
Emphasizes
medium
sounds.
Emphasizes
high sounds.
Increase the
SVC setting
level.
Emphasizes
front
speakers.

How to operate the AUDIO CONTROL

Button operation (Press [SELECT] button)
Lower Right
Softens low
-
sounds.
Softens
-
medium
sounds.
Softens high
-
sounds.
Decrease the
-
SVC setting
level.
Emphasizes Emphasizes
rear right
speakers. speakers.
X
XI
Left
-
-
-
-
Emphasizes
left speakers.
61