How To Operate The Tuner; Listening To The Tuner; Tuning To A Station; Operations During Rotary Mode - Fujitsu Ten Eclipse CD7000 Manuel D'utilisation

How to operate the tuner

ATTENTION
• If stations have been stored in memory,
pressing a button from [1] to [6] will directly
select a station. (Refer to "Manually setting
stations into memory" on page 38)

Listening to the tuner

1
Switch to tuner mode.
For details, refer to "Switching Audio
Modes" on page 17.

Tuning to a station

There are automatic and manual methods for
setting stations in memory. The main unit will
accept up to 24 stations in memory: 6 in AM 18 in
FM (6 each for FM1, FM2 and FM3.) (Initial
setting)
Press the [RTN/BAND] button for
1
less than one second to switch to
the desired FM, AM bands.
Radio bands will switch from FM1 o
FM2 o FM3 o AM in order each time
the button is pressed.
Press the [SELECT] (Right/Left)
2
button to tune to a station.
Right:
Tunes to higher frequencies.
Left:
Tunes to lower frequencies.

How to operate the tuner

Press and hold the [SELECT]
3
(Right/Left) button to start the
automatic station search.
:
Right
Starts searching toward higher
frequencies.
:
Left
Starts searching
frequencies.
ATTENTION
At times, it may be difficult to maintain optimum
reception because the antenna affixed to your
vehicle is in motion constantly (relative to the
broadcast antenna), encountering continuous
variation in the received radio signals' strength.
Other factors affecting
interference from natural obstacles, sign posts,
etc.
When an optional HD Radio tuner unit is
connected, digital broadcasts have reception
priority. (U.S.A. only)

Operations during rotary mode

1
Turn the [VOL] button.
Turn to the right:
Tunes to higher frequencies.
Turn to the left:
Tunes to lower frequencies.
toward lower
V
VI
reception include
37