How To Turn The Security Indicator On/Off; How To Read The Electronic Serial Number - Fujitsu Ten Eclipse CD7000 Manuel D'utilisation

Various Settings
Once a security code has been
2
recorded, press the button [5] and
[SCREEN] button simultaneously
for more than two seconds.
The ACC security function will be
activated. Press the button [5] and
[SCREEN] button simultaneously for
two seconds or more again to cancel
the ACC security function.
ATTENTION
• If the vehicle's battery is disconnected at
times such as during servicing,
security will be canceled.
• When ignition switch is turned OFF and
back to ACC, the operation all button is
disabled. If this happen, resume normal
operation. (Refer to "How to resume normal
operation (ESN security lock out)" on page
48.)
How to turn the security
indicator on/off
Once ESN security is activated, the indicator
flashes whenever the vehicle's ignition switch is
turned off, warning potential thieves that the main
unit is protected. However, if do not want this
visible deterrent, it may be turned off.
With the main unit in standby,
1
press the button
[SCREEN] button and hold both for
more than one second.
[IND. FLASH] or [IND.-----] appears
2
on the display.
[IND. FLASH] means the security
indicator will flash when the vehicle's
ignition switch is off, and [IND.-----]
means it will not. Repeat the above
steps to reactivate the flash mode.
50
How to read the Electronic
Serial Number
Check that the main unit is in
1
standby.
Press and hold the button [4], then
2
[SCREEN] button, and hold both
for more than one second.
[ESN] appears on the display, followed
by an eight-digit number; this number
is your electronic serial number (ESN).
You may use this number to identify
ACC
your Eclipse CD7000 in the event of
theft recovery.
[2], then