Table des Matières
Publicité
Overview
4. Transport
The product integrates several handles to
facilitate handling to the installation site.
To transport the boiler to the installation
site, always use the lower grips and top
handles as shown.
J Positions accepted
Observe the recommendations and handling on the packaging of the water heater.
5. Working principles
The heat pump water heater uses unheated air to heat
domestic hot water.
The coolant in the heat pump sets up a thermodynamic
cycle which allows the energy from the unheated ambient
air or the outside air to be transferred to the water in the
cylinder.
The air is passed through the device by a fan, ventilating the
various components including the evaporator.
As it passes through the evaporator, the coolant evaporates
and conveys calories to the intake air.
The compressor compresses the coolant causing its
temperature to rise.
This heat is transmitted by the condenser to the domestic
water stored in the cylinder.
The coolant expands in the thermostatic expansion valve
and cools down. It is then once again ready to receive heat
in the evaporator.
The colder the air, the harder it is to withdraw calories from
it. Similarly, the higher the hot water setting, the harder it is
for the heat pump to return the calories withdrawn
Installation
Operation
Maintenance
L Positions forbidden
Hot
Water
connection
32
Warranty
Air flow
Air flow
intake
exhaust
Cold
Water
connection
Publicité
Chapitres
Table des Matières
