Counter Check - Sharp R-CD1200M Mode D'emploi

Procedure
0
1
2 Enter memory number.
(After entering the
memory number, the
memory setting of each
content is shown for
1.5 seconds at 0.3 second
intervals until the STOP/
CLEAR pad is pressed.)
STOP
CLEAR
3 Press the STOP/CLEAR pad
to exit from the Custom Help
Function.
NOTES:
1. If is displayed at step 2 the memory has not
CHECK
been programmed.
2. Multiple memories can be checked until the STOP/
CLEAR pad is pressed to exit from the Custom Help
Function.
3. The way to enter memory numbers depends on the
programmed Memory Input Method.
4. When Express Defrost is set for 30 minutes in
the memory,
repeatedly at step 2.
7. Counter Check/Clear
Confi rm counters are set to "0" before using oven for
the fi rst time.

Counter Check

Counter check can be used to check the total number of
times the oven has been used, or the number of times
each pre-programmed memory pad, manual cooking,
or Express Defrost has been used.
Total usage Press the CUSTOM HELP pad twice
within 2 seconds, then enter 7. Total
usage will be displayed.
Display
NO. CHECK
NO. CHECK
After about 1 sec.
CHECK
CHECK
CHECK
CHECK
CHECK
CHECK
and are displayed
To check more than one counter
Press each pad as indicated below, after the previous
usage is displayed.
Total each
memory usage
Total manual
cooking usage
Total Express
Defrost usage
* Suppose you want to know total usage and each
memory usage. In this case the oven was used 8268
times and memory 1 in any Memory Input Method
was used 513 times.
Procedure
CUSTOM
x 2
HELP
1 Press the CUSTOM
HELP pad twice within
2 seconds, then enter
7. Total usage will be
displayed.
2 Enter memory
number 1, to check
the total memory
usage of memory 1.
NOTES:
1. To exit from Counter Check, press the STOP/CLEAR
pad.
2. Each counter will count up to 9999, and then will
automatically reset to 0 and begin counting again.
3. As shown in the above example, multiple counters
can be checked before pressing the STOP/CLEAR pad
to exit.
4. Only Dual Digit Input Method can be used when
inputting memory numbers in Counter Check/Clear.
EN-14
Input memory number.
Press the SELECT TIME
pad.
Press the EXPRESS
DEFROST pad.
Display
After about 1 sec.
7
CHECK
0
NO. CHECK
1
NO. CHECK
After about 1 sec.
CHECK