Program & Customize; Custom Help - Sharp R-CD1200M Mode D'emploi

PROGRAM & CUSTOMIZE

Custom Help

You can check your oven settings and customize your
oven by changing Custom Help settings.
The CUSTOM HELP pad has 11 operations.
1. Selecting Memory Input Method
2. Selecting Auto Start Operation
3. Program Lock Setting
4. Audible Signal Sound Volume Setting
5. Cooking Completion Signal Setting
6. Memory Check
7. Counter Check/Clear
8. Air Intake Filter Counter
9. Selecting Operation in case of Magnetron Failure
10. Multiplication Factors for Double/Triple Quantity
11. Express Defrost Setting
To use Custom Help Function, press the CUSTOM HELP
pad twice within 2 seconds, and desired option pads.
See detailed instructions below.
NOTE : You will hear an audible signal the second time
the CUSTOM HELP pad is pressed to indicate that you
have entered Custom Help.
1. Selecting Memory Input Method
Your oven has 3 ways to select memory numbers.
CH11 : Dual Digit Input (100 memory banks)
CH12 : Single Digit Input (10 memory banks)
= Factory Setting
CH13 : Repeat Digit Input (30 memory banks)
To set Input Method
Press the CUSTOM HELP pad twice within 2 seconds then
enter the numbers
1,1 for Dual Digit Input
1,2 for Single Digit Input
1,3 for Repeat Digit Input
Press the START pad to save settings and the STOP/
CLEAR pad to exit from the Custom Help Function.
* Suppose you want to set Repeat Digit Input.
Procedure
1 Press the CUSTOM HELP pad
CUSTOM
x 2
twice within 2 seconds.
HELP
1 3 2 Enter 1,3 for Repeat Digit
Input.
3 Press the START pad to save
START the setting.
4 Press the STOP/CLEAR pad
STOP
to exit from the Custom Help
CLEAR
function.
2. Selecting Auto Start Operation
Your oven has 2 ways to start memory cooking.
CH21 : Auto Start OFF
CH22 : Auto Start ON = Factory Setting
The factory setting is Auto Start ON. Under Auto Start
ON, cooking will automatically start after the memory
number is input. Under Auto Start OFF, cooking will not
begin until the START pad is pressed.
To set AUTO START
Press the CUSTOM HELP pad twice within 2 seconds then
enter the numbers
2, 1 for Auto Start OFF
2, 2 for Auto Start ON
Press the START pad to save settings and the STOP/
CLEAR pad to exit from the Custom Help Function.
* Suppose you want to set Auto Start OFF.
CUSTOM x 2
HELP
2 1
START
STOP
CLEAR
3. Program Lock Setting
You can select Program Lock ON or OFF
CH31 : Program Lock OFF = Factory Setting
CH32 : Program Lock ON
Program Lock OFF is the Factory setting. Program Lock
prevents accidental changes to settings. When the
CUSTOM HELP pad is pressed twice within 2 seconds
in program Lock ON, the LOCK indicator will light up.
Turn Program Lock OFF when you want to change the
settings.
To turn Program Lock ON/OFF
Press the CUSTOM HELP pad twice within 2 seconds then
enter the numbers
3, 1 for Program Lock OFF
3, 2 for Program Lock ON
Press the START pad to save settings and the STOP/
CLEAR pad to exit from the Custom Help Function.
EN-12
Procedure
1 Press the CUSTOM HELP pad
twice within 2 seconds.
2 Enter 2, 1 for Auto Start OFF.
3 Press the START pad to save
the setting.
4 Press the STOP/CLEAR pad
to exit from the Custom Help
Function.